1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear combination lamp cover (A).
|
3. |
Remove the mounting nuts (4EA).
|
4. |
Remove the rear combination lamp (B) after disconnecting the connector
(A).
|
5. |
Replace turn signal lamp (A) and stop/tail lamp (B) by turning
the sockets counterclockwise.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the trunk trim.
(Refer to Body - "Trunk Trim")
|
3. |
Remove the rear lamp assembly after removing the nuts (3EA) and
connector (A).
|
4. |
Replace the backup lamp (A) and stop lamp (B) by turning the sockets
counterclockwise.
[General Type]
[LED Type]
|
Room Lamp Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the
room lamp connector (A).
...
Canister Close Valve (CCV) Installation
•
Install the component with the specified torques.
•
...
Fuel Tank Pressure Sensor (FTPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...