1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the rear wheel and tire (A) from rear hub .
|
3. |
Remove the brake caliper mounting bolts, and then place the brake
caliper assembly (A) with wire.
|
4. |
Loosen the mounting screws and then brake disc (A).
|
5. |
Loosen the bolts and then remove the hub bearing (A).
|
6. |
Install in the reverse order of removal.
|
7. |
Check the rear alignment.
(Refer to Suspension System - "Rear Alignment")
|
Accelerator Pedal Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...
PTC Heater Description
The PTC (Positive Temperature Coefficient) heater is installed at the
exit or the backside of the heater core.
The PTC heater is an electric heater using a PTC element as an auxiliary
hea ...
Fuel Tank Pressure Sensor (FTPS) Specification
Pressure [kPa (kgf/cm², in H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5
...