Kia Forte: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Oil Seal Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install a new rear oil seal.
(1)
Apply engine oil on the edge of new oil seal.
(2)
Using SST (09231-H1100, 09214-2E000) and a hammer, tap in the oil seal (A) until the SST face is aligned with the cylinder block assembly rear face.

2.
Install the other parts reverse order of removal.
Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") Remove the manual transaxle. (Refer to Manual ...

Piston and Connecting Rod Components
1. Piston ring 2. Snap ring 3. Piston pin 4. Piston 5. Connecting rod 6. Connecting rod upper bearing 7. Connecting rod lower bearing 8. Connecting rod bearing cap ...

See also:

Starter Specification
Starter [Non-ISG type] Item Specification Rated voltage 12 V, 1.2 kW The number of pinion teeth 13 Performance [No-load, 11 V] ...

Sunroof Sunshade Replacement
1. Remove the sunroof assembly. (Refer to Sunroof - "Sunroof Assembly") 2. After loosening the mounting screws, then remove th ...

Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted w ...

Copyright © www.kifomanual.com 2014-2024