1. |
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Remove the rear brake caliper.
(Refer to Brake System - "Rear Disc Brake")
|
4. |
Loosen the bolt and then remove the wheel speed sensor cable (A).
|
5. |
Loosen the bolt and then remove the rear shock absorber (A) from
the frame.
|
6. |
Loosen the bolt & nut and then remove the rear shock absorber
(A) from the torsion beam axle.
|
7. |
Remove the rear wheel housing (A).
|
8. |
Loosen the mounting bolts and then remove the torsion beam axle
(A) from the frame.
|
9. |
Remove the rear hub assembly.
(Refer to Driveshaft and axle - "Rear Hub - Carrier")
|
10. |
Installation is the reverse of removal.
|
11. |
Check the rear alignment.
(Refer to Rear Suspension System - "Rear Alignment")
|
Installation
1.
Install in the reverse order of removal.
A.
...
Filler-Neck Assembly Removal
1.
Open the fuel filler door and unfasten the filler-neck assembly
mounting screw (A).
2.
Remove the rear-LH wheel, tire, and the i ...
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...