There may be some residual pressure even after “Release Residual
Pressure in Fuel Line” work, so cover the hose connection with a shop
towel to prevent residual fuel from spilling out before disconnecting
any fuel connection.
|
1. |
Turn the ignition switch OFF and disconnect the battery (-) cable.
|
2. |
Remove the fuel pump fuse (A).
|
3. |
Connect the battery (-) cable.
|
4. |
Start the engine and let idle, and then turn the ignition switch
OFF after the engine has stopped on its own.
|
5. |
Disconnect the battery (-) cable, and then install the fuel pump
fuse.
|
6. |
Connect the battery (-) cable.
|
7. |
Delete the Diagnostic Trouble Code (DTC) related the fuel pump
fuse with the GDS.
|
Input Speed Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...
Starting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots, sandals, etc.) may interfere with your ability to use the
brake and acc ...