1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
3. |
Remove the shower duct (A).
|
4. |
Disconnect the stop lamp switch connector (A).
|
5. |
Remove the brake pedal member mounting bolt (A).
|
6. |
Remove the snap pin (A) and clevis pin (B).
|
7. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Inspection
Front brake disc thickness check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Components
1. Control shaft complete
2. Back-up lamp switch
3. Vehicle speed sensor
4. Transaxle housing
5. Transaxle case
...
Heater & A/C Control Unit (DATC) Self Diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code
After the display panel blinks three times every 0.5 second, the
...