Kia Forte: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
|
| 3. |
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
|
| 4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
|
| 5. |
Disconnect the light switch connector (A) and the wiper switch
connector (B).
|
| 6. |
[RHD]Remove the wiper switch (A) by pushing the lock pin (B).
|
| 7. |
Loosen the screws (2EA) from the multifunction switch assembly
(A).
|
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
Installation
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lowe ...
See also:
Ambient Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect ambient temperature sensor.
3.
Check the resistance of the ambie ...
ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function
Connector [CNG-MA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #1) control output
Ignition Co ...
Sunvisor
Use the sunvisor to shield direct light through the front or side windows.
To use the sunvisor, pull it downward. To use the sunvisor for the side window,
pull it downward, unsnap it from the br ...
Copyright © www.kifomanual.com 2014-2024