Kia Forte: Removal - Ignition Switch Assembly - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Ignition Switch Assembly / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Low Panal")
3.
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
4.
Remove the wiper switch.
(Refer to "Multifunction switch")
5.
Remove the ignition switch after disconnecting the ignition switch 6P connector.
6.
Remove the key warning/immobilizer connector (A).

7.
After loosening the screw, remove the key warning switch and key Illumination (B).
8.
Pushing lock pin with key ACC.
9.
Remove the key lock cylinder (A).

Ignition Switch Assembly
...

Installation
1. Install the key lock cylinder. 2. Install the key warning switch and key Illumination. 3. Install the key wa ...

See also:

Temperature Control Actuator Replacement
[Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body -& ...

Cooling Fan Components
1. Cooling fan 2. Fan motor 3. Cooling fan shroud 4. Resister ...

Starting the engine
WARNING - Proper footwear Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots, sandals, etc.) may interfere with your ability to use the brake and acc ...

Copyright © www.kifomanual.com 2014-2024