Pressure Side Impact Sensor |
|
1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Remove the front door trim.
(Refer to Body - "Front door trim")
|
3. |
Disconnect the pressure side impact sensor connector (A).
|
4. |
Loosen the pressure side impact sensor mounting screws (B) and
then remove the pressure side impact sensor.
|
1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
|
3. |
Remove the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
4. |
Disconnect the side impact sensor connector (A).
|
5. |
Loosen the side impact sensor mounting bolt and then remove the
side impact sensor (B).
|
Rear Door Module Replacement
(4Door, 5Door)
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Disconnec ...
Starter Components
[NON-ISG Type]
1. Front bracket assembly
2. Magnet switch assembly
3. Lever
4. Reducer assembly
5. Lever stop
6. Gasket sheet
7. Yoke assembly
8. Armat ...
SS-B Solenoid Valve(ON/OFF) Installation
1.
Install in the reverse order of removal.
•
...