Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the battery (A) and ECM (B).
|
| 3. |
Remove the master cylinder.
(Refer to Master Cylinder)
|
| 4. |
Remove the snap pin (A) and clevis pin (B).
|
| 5. |
Remove the mounting nuts (A).
|
| 6. |
Disconnect the vacuum hose (A) from the brake booster.
|
| 7. |
Remove the brake booster (B).
|
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Inspection
1.
Inspect the check valve in the vacuum hose.
Do not remove the check va ...
See also:
PTC Heater Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel" ...
Piston and Connecting Rod Components
1. Piston ring
2. Snap ring
3. Piston pin
4. Piston
5. Connecting rod
6. Connecting rod upper bearing
7. Connecting rod lower bearing
8. Connecting rod bearing cap ...
Circuit Diagram - ESC (4)
ESC Connector Input/ Out put
Wire No.
Designation
Current
max.permissible wire
resistance R_L (mΩ)
max
min
1 ...
Copyright © www.kifomanual.com 2014-2024