1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the vacuum pump connector (A).
|
3. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
4. |
Disconnect the vacuum hose clip (A) and wiring harness clip (B)
from the vacuum pump bracket.
|
5. |
Remove the under covers (A).
|
6. |
Remove the intercooler inlet hose (A).
|
7. |
Disconnect the vacuum hose (A).
|
8. |
Loosen the vacuum pump bracket bolts (A) and then remove vacuum
pump and bracket.
|
9. |
Remove the bolts and then remove the vacuum pump (A) and lead
wire assembly (B) from the bracket (C).
|
Rear Alignment Adjustment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Control Shaft Complete Description
Component location : Control shaft
assembly is mounted on the top of the manual transaxle
Function : Change the gear by shifting
a shift lever. ...
Installation
WCS(Weight Classification System) is utilizing a robust weight
measuring technology. Thus, if any of the following condi ...