1. |
Turm ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the battery (A) and ECM (B).
|
3. |
Disconnect the brake fluid level switch connector (A), and remove
the reservoir cap.
|
4. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
5. |
Disconnect the brake tube (A) from the master cylinder by loosening
the tube flare nut.
|
6. |
Remove the clutch hose (B). [MT only]
|
7. |
Remove the master cylinder (B) from the brake booster after loosening
the mounting nuts (A).
|
Battery Installation
1.
Install in the reverse order of removal.
Battery (-)terminal installation:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft)
...
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
PTC Heater Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel" ...