|
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
2. |
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
3. |
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim")
|
4. |
Remove the canter pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
5. |
Remove the rear package tray trim. (4Door, 2Door)
(Refer to Interior Trim - "Rear Package Tray Trim")
|
6. |
Remove the sunvisor and retainer.
(Refer to Roof Trim - "Sunvisor")
|
7. |
Remove the assist handle.
(Refer to Roof Trim - "Assist Handle")
|
8. |
Remove the garment hook. (2Door)
(Refer to Roof Trim - "Garment Hook")
|
9. |
Remove the overhead console lamp.
(Refer to Body Electrical System - "Overhead Console Lamp")
|
10. |
Remove the room lamp.
(Refer to Body Electrical System - "Room Lamp")
|
11. |
Remove the rear window glass.
(Refer to "Rear Window Glass")
|
12. |
Tilt the front seat back towards the rear of the vehicle as far
as possible.
|
13. |
Remove the ECM mirror cover (A).
|
14. |
Disconnect the ECM mirror connector (B).
|
15. |
Remove the auto defog sensor cover (A).
|
16. |
Disconnect the auto defog sensor connector (B).
|
17. |
Disconnect the roof trim main connector (A) and the mounting clips
(B) in the front pillar.
[Driver's]
|
18. |
Using a clip remover, detach the roof trim assembly mounting clips.
|
19. |
Pull back the roof trim assembly (A) through the place where the
rear window glass was removed.
|
20. |
Remove the vanity lamp.
(Refer to Body Electrical System - "Vanity Lamp")
|
21. |
Remove the hands free mic.
(Refer to Body Electrical System - "Hands Free Mic")
|
22. |
Remove roof trim wiring harness (A) from the roof trim (B).
|
23. |
Install in the reverse order of removal.
|
Front Strut Assembly Inspection
1.
Check the strut bearing for wear and damage.
2.
Check the spring upper and lower seat for damage and deterioration.
3.
...
Transaxle Oil Temperature Sensor Description
Transaxle Oil Temperature Sensor(OTS) monitors the automatic transaxle
fluid's temperature and conveys the readings to Transaxle Control Module(TCM).
It is an Negativen Thermal Coefficien ...
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...