Kia Forte: Seat Belt Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat Belt Switch Removal
| 1. |
Remove the front seat.
|
| 2. |
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
|
Seat Belt Switch Inspection
1.
Remove the connector from the switch.
2.
Check for continuity between terminals.
Seat belt condition
Continu ...
Seat Belt Switch Installation
1.
Install in the reverse of removal.
...
See also:
Shift Cable Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Shift lever knob & boots assembly
5. Manual control lever
6. Retainer
...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Adjustment
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~
0.08in), conform to below.
1.
Disconnect the s ...
Copyright © www.kifomanual.com 2014-2024