Kia Forte: Starter Cleaning
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Cleaning
| 1. |
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation
wipe these parts with a cloth only.
|
| 2. |
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory and sol-vent
will wash lubrication from the clutch.
|
| 3. |
The drive unit may be cleaned with a brush moistened with cleaning
solvent and wiped dry with a cloth.
|
Starter Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...
Starter Relay Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
...
See also:
Cylinder Head Reassembly
•
Thoroughly clean all parts to be assembled.
•
...
ETC (Electronic Throttle Control) System Circuit Diagram
(M/T)
(A/T)
...
Crankshaft Position Sensor (CKPS) Specification
Item
Specification
Coil Resistance(Ω)
774 ~ 946 [20°C (68°F)]
...
Copyright © www.kifomanual.com 2014-2024