Kia Forte: Starter Disassembly (NON-ISG Type) - Starting System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Disassembly (NON-ISG Type)

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Disassembly (NON-ISG Type)

1.
Disconnect the M-terminal (A) on the magnet switch assembly.

2.
After loosening the screws (A), detach the magnet switch ssembly (B).

3.
Loosen the through bolts (A).

4.
Remove the brush holder assembly (A), armature assembly (B) and yoke assembly (C).

5.
Remove the gasket sheet (A) and lever stop (B).

6.
Remove the reducer assembly (A) and lever (B).

7.
Press the stopper (A) using a socket (B).

8.
After removing the stop ring (A) using stop ring pliers (B).

9.
Disconnect the stopper (A), overrunning clutch (B) and internal gear (C).

  
Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).

10.
Reassembly is the reverse of disassembly.
Starter Installation
1. Install in the reverse order of removal. Starter installation bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) ...

Starter Reassembly
1. Reassemble in the reverse order of disassembly. ...

See also:

Automatic transaxle operation
The automatic transaxle has 6 forward speeds and one reverse speed. The individual speeds are selected automatically, depending on the position of the shift lever. ✽ NOTICE The first few ...

Specifications
Item Specifications Working voltage  DC 12V Operating force 9.8 ± 2.9N (1.0 ± 0.3kg, 7.2 ± 0.7lb) Working temperature ...

Crankshaft Inspection
1. Check the crankshaft bearing oil clearance. (1) To check main bearing-to-journal oil clearance, remove the lower crankcase and lo ...

Copyright © www.kifomanual.com 2014-2024