1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
|
3. |
Disconnect the sunroof motor (A) connector.
|
4. |
Ground the terminals as below table, and check that the sunroof
unit operates.
|
5. |
Make these input tests at the connector. If any test indicates
a problem, find and correct the cause, then recheck the system. If all
the input tests prove OK, the sunroof motor must be faulty; replace
it.
|
Front Door Latch Component Location
(4Door, 5Door, 2Door)
1. Front door latch
...
Fuel Pump Motor Removal
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender conn ...
System Overview
PAS(Parking Assist System) is an electronic driving aid device warning
driver to be cautious when they park or speed low after detecting an object
on side and behind of vehicle by using the f ...