1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the temperature control actuator connector.
|
3. |
Verify that the temperature control actuator operates to the cool
position when connecting 12V to terminal 3 and grounding terminal 7.
Verify that the temperature control actuator operates to the warm
position when connected in reverse.
|
4. |
Connect the temperature control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 7.
Specification
It will feedback the current position of the actuator to the controls.
|
7. |
If the measured voltage is not within specification, substitute
with a known-good temperature control actuator and check for proper
operation.
|
8. |
Replace the temperature control actuator if it is proved that
there is a problem with it.
|
Rear Drum Brake
Components
1. Shoe hold down pin
2. Shoe adjuster
3. Upper return spring
4. Adjusting lever
5. Shoe
6. Adjusting spring
7. Lower return spring
8. Shoe hold spri ...
Rear Transverse Trim Replacement
(5Door)
•
Put on gloves to protect your hands.
...
Removal
1.
Drain the brake fluid through the bleed plug (A).
•
...