Kia Forte: Thermostat Inspection - Cooling System - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Thermostat Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Thermostat Inspection

1.
Immerse the thermostat in water and gradually heat the water.

2.
Check the valve opening temperature.
If the valve opening temperature is not as specified, replace the thermostat.

Valve opening temperature:
88 ± 1.5°C (190.4 ± 34.7°F)
Full opening temperature: 100°C (212°F)

3.
Check the valve lift.
If the valve lift is not as specified, replace the thermostat.

Valve lift : 8 mm (0.3 in.) or more at 100°C (212°F)

Thermostat Removal and Installation
   Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the ...

Thermostat Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting nu ...

See also:

Cowl Side Trim Replacement
   • Put on gloves to protect your hands. &n ...

Audio system
✽ NOTICE If you install an after market HID head lamp, your vehicle’s audio and electronic device may malfunction. Glass antenna (if equipped) When the radio power switch is turned on w ...

Cruise Control
The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, accelerate and res ...

Copyright © www.kifomanual.com 2014-2024