Disassembly of the thermostat would have an adverse effect, causing
a lowering of cooling efficiency. Do not remove the thermostat, even
if the engine tends to overheat.
|
1. |
Drain engine coolant so its level is below thermostat.
|
2. |
Disconnect the radiator lower hose.
(Refer to Cooling System - “Radiator Hose”)
|
3. |
Remove the water inlet fitting (A) and thermostat (B).
|
4. |
Remove the intake manifold.
(Refer to Intake and Exhaust System - "Intake Manifold")
|
5. |
Remove the bypass hose (A).
|
6. |
Unfasten the heater pipe mounting bolts (B) and then remove the
heater pipe.
|
7. |
Install in the reverse order of removal.
|
8. |
Fill the engine coolant.
|
9. |
Start the engine and check for leaks.
|
10. |
Recheck the coolant level.
|
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Direct control VFS[UD/B]
▷ Control type : Normal high type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current value(mA)
...
Manifold Absolute Pressure Sensor (MAPS) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...