|
Mark all wiring and hoses to avoid misconnection.
|
1. |
Disconnect the battery negative terminal.
|
2. |
Remove the RH front wheel.
|
3. |
Remove the RH under cover.
|
4. |
Remove the engine cover.
|
5. |
Remove the cylinder head cover.
(Refer to Cylinder Head Assembly – “Cylinder Head Cover”)
|
6. |
Drain engine oil and remove the oil pan.
(Refer to Lubrication system – “Oil Pan”)
|
7. |
Remove the engine mounting bracket.
(Refer to Engine And Transaxle Assembly - "Engine Mounting")
|
8. |
Remove the crankshaft damper pulley.
(Refer to Timing System – “Crankshaft Damper Pulley")
|
9. |
Remove the water pump.
(Refer to Cooling System - "Water pump")
|
10. |
Remove the A/C compressor.
(Refer to Heating,Ventilation, Air Conditioning - "Compressor")
|
11. |
Remove the front engine hanger (A).
|
12. |
Remove the alternator.
(Refer to Engine Electrical System – “Alternator”)
|
13. |
Remove the timing chain cover (A) by gently prying the gaps between
the cylinder head and cylinder block.
|
Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Components Location
1. Converter housing
2. Automatic transaxle upper mounting bolt
3. Shift cable bracket
4. Manual control lever
5. Rear cover
6. Oil cooler tube
7. Oil level plug
8. Val ...