1. |
Measure the tread depth of the tires.
|
2. |
If the remaining tread depth (A) is less than the limit, replace
the tire.
|
Checking For Pull And Wander |
1. |
Rotate the front right and front left tires, and perform a road
test in order to confirm vehicle stability.
|
2. |
If the steering pulls to the opposite side, rotate the front and
rear tires, and perform a road test again.
|
3. |
If the steering continues to pull to one side, rotate the front
right and left tires again, and perform a road test.
|
4. |
If the steering continues to pull to the opposite side, replace
the front wheels with new ones.
|
Cylinder Head Cover Installation
1.
Install cylinder head cover.
(1)
The hardening sealant located on the cylinder head cover
and the gap between the timing chain co ...
Camshaft Position Sensor (CMPS) Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Line Pressure Control Solenoid Valve Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...