Kia Forte: TJ Joint Inspection - Driveshaft Assembly - Driveshaft and axle - Kia Forte TD 2014-2018 Service ManualKia Forte: TJ Joint Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Inspection

1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
3.
Check the TJ boots for damage and deterioration.
TJ Joint Replacement
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

TJ Joint Installation
1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

See also:

Rear Torsion Beam Axle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

General Information
The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the drive ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

Copyright www.kifomanual.com 2014-2025