Kia Forte: Transmitter Code Registration (Using GDS)
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Transmitter Code Registration (Using GDS)
| 1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
| 2. |
Select the vehicle model and then do "CODE SAVING"
|
| 3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the
screen will be shown as below.
|
| 4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1 to 4
and then code saving is completed.
|
Transmitter Inspection
1.
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
2.
Remove the battery (A) and check ...
See also:
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Heated Oxygen Sensor (HO2S) Specification
HO2S [Bank 1/Sensor 1] (Linear type)
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2] (Binary type)
...
Opening the tailgate
The tailgate is locked or unlocked when all doors are locked or unlocked
with the transmitter (or smart key) or central door lock switch.
If unlocked, the tailgate can be opened by pressing ...
Copyright © www.kifomanual.com 2014-2024