1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to Underdrive Brake Control Solenoid Valve - "Specifications")
|
Timing Chain Cover Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
Fluid Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid (ATF) level is not normally
required during scheduled ...
Heated Oxygen Sensor (HO2S) Circuit Diagram
(M/T)
(A/T)
...