Kia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description
Overdrive Clutch(OD/C) Control Solenoid Valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the Overdrive Clutch(OD/C)
...
See also:
SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
▷ Control type : Normal low type
Control pressure kpa (kgf/cm², psi)
490.33(5.0, 71.12)
Internal resistance(Ω ...
Intake Air Temperature Sensor (IATS) Circuit Diagram
(M/T)
(A/T)
...
IMS Control Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the seat side cover (A).
3.
Disconnect the p ...
Copyright © www.kifomanual.com 2014-2024