Kia Optima Manuals

Kia Forte: Valve Body Installation - Hydraulic System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Valve Body Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body Installation

1.
Install in the reverse order of removal.
  
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
  
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
•
Replace the gasket (A) before reinstalling the valve body cover.

Valve Body Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Clutch & Brake
...

See also:

Air Cleaner Components
1. Air intake hose 2. Air cleaner cover 3. Air cleaner filter 4. Air cleaner body 5. Resonator 6. Air duct 7. Air intake shield ...

Rear Hub - Carrier Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the brake disc for scoring and damage. 3. C ...

Installation
Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Categories


Copyright © www.kifomanual.com 2014-2024