1. |
Turn ignition switch OFF.
|
2. |
Disconnect the VCMA connector.
|
3. |
Check that the VCMA is not stuck by foreign material.
|
4. |
Measure resistance between motor (+) and (-) control terminals
of the motor.
|
5. |
Check that the resistance is within the specification.
|
6. |
Measure resistance between voltage supply terminal and ground
terminal of the position sensor.
|
7. |
Check that the resistance is within the specification.
|
Occupant detection system
Your vehicle is equipped with an occupant detection system in the front passenger's
seat.
The occupant detection system is designed to detect the presence of a properly-seated
front passeng ...
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Rear Door Belt Inside Weatherstrip Replacement
(4Door, 5Door)
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door bel ...