Kia Forte: Variable Charge Motion Actuator (VCMA) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the VCMA connector (A).
|
| 3. |
Remove the VCMA (A) after removing 3 installation bolts.
|
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
See also:
Installation
1.
Install in the reverse order of removal.
Use a new washer (A) whenever ...
On-board Refueling Vapor Recovery (ORVR) valve Installation
1.
Installation is the reverse of removal.
...
Cylinder Block Disassembly
•
Use fender covers to avoid damaging painted surfaces.
•
...
Copyright © www.kifomanual.com 2014-2024