A : Wiper speed control (front)
B : Intermittent control wipe time adjustment
C :Wash with brief wipes (front)
D : Rear wiper/washer control
E :Wash with brief wipes (rear)
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it. The wipers will operate continuously if the lever is held in this position.
OFF :
Wiper is not in operation
INT :
Wiper operates intermittently at the same wiping intervals. Use this mode in a light rain or mist. To vary the speed setting, turn the speed control knob.
LO :
Normal wiper speed
HI :
Fast wiper speed
If there is a heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
Tail Gate Latch Component Location
(5Door)
1. Tail gate latch assembly
...
Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - " Manual Transaxle")
2.
Remove the clutch release beari ...
Telemetics Unit (TMU) Inspection
1.
After replacing the TMU unit, access Dealer Engineering Mode in
head unit.
(Refer to MTS system - "TMU Dealer Engineering Mode")
2 ...