Kia Forte: 35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the Solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
(Refer to 35R Clutch Control Solenoid Valve - "Specifications")
|
35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
See also:
Engine Oil Inspection
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Piston and Connecting Rod Inspection
Connecting Rod
1.
Check the connecting rod side clearance.
Using a feeler gauge, measure the end play while moving the connecting
rod back and forth.
...
Copyright © www.kifomanual.com 2014-2025