Kia Forte: Accelerator Position Sensor (APS) Inspection - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Accelerator Position Sensor (APS) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Accelerator Position Sensor (APS) Circuit Diagram
(M/T) (A/T) ...

Accelerator Position Sensor (APS) Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

See also:

Seat Heater (Air Ventilation) Component Location
...

Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted w ...

Alternator Specification
Alternator [Non-ISG type] Item Specification Rated voltage 13.5V, 90A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC ...

Copyright www.kifomanual.com 2014-2026