Kia Forte: Crankshaft Position Sensor (CKPS) Inspection

Crankshaft Position Sensor (CKPS) Circuit Diagram

(M/T) (A/T) ...

Crankshaft Position Sensor (CKPS) Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) ...

See also:

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Blower Resistor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the blower resistor connector (A) and then remove the blower resistor (B) af ...

Room Lamp Installation
Room Lamp 1. Reconnect the connector. 2. Install the room lamp assembly. 3. Install the lens. ...