Kia Forte: Adjustment
| Clutch Release Cylinder Air Bleeding Procedure |
|
| 1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
| 2. |
Refill the clutch master cylinder with the specified fluid.
|
| 3. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
| 4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
| 5. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and re-tighten it with the pedal pressed. Raise it again, then.
|
| 6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
|
| 7. |
Refill the clutch master cylinder with the specified fluid.
|
Installation
1.
Install in the reverse order of removal.
Apply the specified grease to ...
See also:
Auto Defogging Sensor Description
The auto defogging sensor is installed on the front windshield glass.
The auto defogging sensorr senses moisture on the windshild. The air conditioner
control module receives the signal from ...
Shift Lever Removal
1.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
2.
Remove the air duct.
3.
...
Inspection
If any of the following conditions occur, WCS reset and accuracy check
should be performed.
•
The WCS ECU or any of the sensors is replaced.
•
...
Copyright © www.kifomanual.com 2014-2025