Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Multifunction Switch / Installation

1.	Install the multifunction switch.

2.	Install the clock spring.

3.	Install the steering column upper and lower shrouds.

4.

Install the steering wheel.

Make sure the multifunction switch connectors are plugged in properly.

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel") ...

Horn

...

See also:

Removal
1. Separate the push rod (C) after remove the pin (A) and washer (B). 2. Remove the battery. (Refer to Engine Electrical S ...

Engine Control Module (ECM) Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...

Specification
Item Specification Ultrasonic sensor Voltage rating DC 12 V Detecting range 30 cm ~ 120 cm Operation voltage DC 9 ~ 16 ...

Categories

Copyright © www.kifomanual.com 2014-2026