Kia Forte: Alternator Specification
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator Specification
| Item |
Specification |
|
| Rated voltage |
13.5V, 120A |
|
| Speed in use |
1,000 ~ 18,000 rpm |
|
| Voltage regulator |
IC Regulator built-in type |
|
| Regulator Setting Voltage |
External mode |
Refer to below graph |
| Internal mode |
14.55 ± 0.3V |
|
| Temperature Gradient |
External mode |
0 ± 3 mV / °C |
| Internal mode |
-3.5 ± 2mV / °C |
|
※ Regulator Setting Voltage (External mode)
Alternator Description
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...
Alternator On-vehicle Inpection
•
Check that the battery cables are connected to the correct
terminals.
...
See also:
A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) converts the pressure value of high
pressure line into voltage value after measuring it. By converted voltage value,
engine ECU controls the cooling fan by o ...
Blower Resistor Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Front Stabilizer Bar Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Copyright © www.kifomanual.com 2014-2024