Kia Forte: Auto Head Lamp Leveling Device

Auto Light Sensor Installation

1. Reconnect the auto light connector. 2. Install the auto light sensor. ...

Component Location

1. Headlamp leveling device switch 2. Headlamp leveling actuator ...

See also:

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the heater & A/C control unit. (Refer to Heating,Ventilation, Air Conditi ...

IMS Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Telemetics Unit (TMU) Component
Connector Pin Specification No. Pin Name Type From To Description (Wiring Spec.) 1 GND DC Ground TMU Batt ...