Kia Forte: Auto Head Lamp Leveling Unit Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Inspection
| 1. |
Ignition "ON".
|
| 2. |
Turn on the head lamp switch.
|
| 3. |
Check for operation. If the aim of the head lamps changes smoothly
when the head lamp leveling switch is turned.
|
| 4. |
If the operation does not work well, inspect the connector and
terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary,
and recheck the system.
If the terminals look OK, go to step 5.
|
| 5. |
Substitute with a known-good head lamp assembly and check for
proper operation.
|
Auto Head Lamp Leveling Unit Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Sensor angle change.
3.
...
Auto Head Lamp Leveling Unit Removal
1.
Remove the head lamp leveling unit connector (A).
2.
Remove the head lamp leveling unit (B) after loosening the mounting
bolts.
...
See also:
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Rearview camera
The rear view camera will activate with the ignition switch on and the shift
lever in the R (Reverse) position.
Note- during initial start up, system may not display instantly due to the audio
...
Copyright © www.kifomanual.com 2014-2025