Kia Forte: Brake Booster Vacuum Pressure Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor Removal
Brake Booster Vacuum Pressure Sensor can not be replaced separately
due to vacuum leak.
Therefore, the sensor must be replaced with an assembly with the
brake booster.
(Refer to Brake System - Brake Booster)
|
Brake Booster Vacuum Pressure Sensor Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
...
Brake Booster Vacuum Pressure Sensor Installation
Brake Booster Vacuum Pressure Sensor can not be replaced separately
due to vacuum leak.
Therefore, the sensor mu ...
See also:
CVVT Oil Control Valve (OCV) Specification
Item
Specification
Coil Resistance (Ω)
9.4~10.4 [20°C(68°F)]
...
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
...
Limp Home Function
1.
Limp Home By Tester
If the ECM detects the fault of the Immobilizer or transponder,
the ECM will allow limp home function of the immobilizer. Limp home
is o ...
Copyright © www.kifomanual.com 2014-2025