Kia Forte: Brake Switch Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Switch Inspection
| 1. |
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in and when it is released.
|
| 2. |
The stop lamp switch is in good condition if there is no continuity
when plunger (A) is pushed.
|
Brake Switch Description
The present brake switch is used as an input variable for the ISG function
to detect bracke operation. ...
Brake Switch Removal
1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel. (Refer to the Body group-"crash
pad")
3.
...
See also:
Power Mosfet Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
the blower motor.
3. ...
Removal
1.
Disconnect the battery negative cable and wait for at least thirty
seconds.
before beginning work.
2.
Remove the roof tr ...
Rear Hub - Carrier Components
1. Rear torsion beam axle assembly
2. Rear dust cover
3. Rear wheel hub assembly
4. Rear brake disc
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026