Kia Forte: Front Strut Assembly Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Front Suspension System / Front Strut Assembly Inspection
| 1. |
Check the strut bearing for wear and damage.
|
| 2. |
Check the spring upper and lower seat for damage and deterioration.
|
| 3. |
Compress and extend the piston rod (A) and check that there is
no abnormal resistance or unusual sound during operation.
|
Disposal
| 1. |
Fully extend the piston rod.
|
| 2. |
Drill a hole on the (A) section to remove gas from the cylinder.
|
Front Strut Assembly Disassembly
1.
Using the special tool (09546-26000), compress the coil spring
(A).
Tightening torque:
58.3 ~ 73.5N.m (6.0 ~ 7.5kgf.m, 43.4 ~ 54.2 ...
Front Lower Arm Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
See also:
Alternator Description
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...
Piston and Connecting Rod Disassembly
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painte ...
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...
Copyright © www.kifomanual.com 2014-2025