1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Loosen the bolt & nut and then remove the lower arm (A).
|
4. |
Loosen the bolts and nuts and then remove the front lower arm
(A).
|
5. |
Installation is the reverse of removal.
|
6. |
Check the front alignment.
(Refer to Front Suspension System - "Front Alignment")
|
Specification
Item
Specification
Type
Hall sensor
Working voltage
6.5 ~1 5V
Output voltage
VL ≤ 0.5 V
(When output cu ...
Intake Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuato ...