Kia Forte: Camshaft Position Sensor (CMPS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply the engine oil to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage when installation.
|
|
| •
|
Be careful not to damage the sensor housing and the connector.
|
| •
|
Be careful not to damage the O-ring.
|
|
|
1. |
Install in the reverse order of removal.
Camshaft position sensor installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
•
DON’T remove the camshaft position sensor during engine
running or right after eng ...
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
See also:
Seat Belt Switch Removal
1.
Remove the front seat.
2.
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
...
Door Scuff Trim Replacement
(4Door, 5Door)
•
Put on gloves to protect your hands.
...
Room lamp
To turn the room lamp ON or OFF, push the switch.
If your vehicle is not equipped with a map lamp, the room lamp will also turn
on or off as follows.
The room lamp comes on when a door is opene ...
Camshaft Position Sensor (CMPS) Removal
Knock Sensor (KS) Description