Kia Forte: Camshaft Position Sensor (CMPS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Removal
|
| [Bank 1 / Intake] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (B) after removing
the clip (A).
|
| 3. |
Remove the installation bolt (C), and then remove the sensor.
|
| [Bank 1 / Exhaust] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (B) after removing
the clip (A).
|
| 3. |
Remove the installation bolt (C), and then remove the sensor.
|
Camshaft Position Sensor (CMPS) Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Camshaft Position Sensor (CMPS) Installation
•
Install the component with the specified torques.
•
...
See also:
Oil Pressure Switch Removal and Installation
1.
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
Tightening torque :
9.8 ~ 11.8N.m (1 ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Ignition Coil Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026