Kia Forte: Oil Pressure Switch Removal and Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Removal and Installation
| 1. |
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
|
| 2. |
Install in the reverse order of removal.
|
When installing the oil pressure switch, apply seal lock to the
thread.
|
Seal lock : THREEBOND 2403
Thickness : 0.2 ~ 0.4 mm
(0.008 ~ 0.016 in.)
|
Oil Pump Inspection
1.
Remove the relief plunger.
Remove the plug (A), spring (B) and relief plunger (C).
Tightening torque
Plug (A) :
...
Oil Pressure Switch Inspection
1.
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
...
See also:
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Piston and Connecting Rod Components
1. Piston ring
2. Snap ring
3. Piston pin
4. Piston
5. Connecting rod
6. Connecting rod upper bearing
7. Connecting rod lower bearing
8. Connecting rod bearing cap ...
Front Strut Assembly Inspection
1.
Check the strut bearing for wear and damage.
2.
Check the spring upper and lower seat for damage and deterioration.
3.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026