Kia Forte: Canister Close Valve (CCV) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation hose (B).
|
| 5. |
Remove the fuel tank air filter after removing the mounting bolts
(C).
|
| 6. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter after rotating it in the direction
of the arrow in the figure.
|
Canister Close Valve (CCV) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV termina ...
Canister Close Valve (CCV) Installation
•
Install the component with the specified torques.
•
...
See also:
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Power Door Lock Relay Inspection
Diagnosis With GDS
1.
It will be able to diagnose defects of power door lock with GDS
quickly. GDS can operates actuator forcefully, input/output value monitoring
...
Copyright © www.kifomanual.com 2014-2025