Kia Forte: Component Replacement After Deployment
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs.
|
When the front airbag(s) deployed after a collision, replace the following
items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Seat belt pretensioner(s)
|
| - |
Anchor pretensioner(s)
|
| - |
Front impact sensors
|
| - |
SRS wiring harnesses
|
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the
following items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Side impact sensor(s) for the deployed side(s)
|
| - |
SRS wiring harnesses
|
After the vehicle is completely repaired, confirm the SRS airbag system
is OK.
| - |
Turn the ignition switch ON; the SRS indicator should come on
for about six seconds and then go off.
|
Special Service Tools
Tool(Number and Name)
Illustration
Use
Deployment tool
0957A-34100A
Airbag deployment tool.
Deployment adapter
0957A-3Q100
...
General Information
The supplemental restraint system (SRS) is designed to supplement the
seat belt to help reduce the risk or severity of injury to the driver and passenger
by activating and deploying the drive ...
See also:
Sealant
Items
Specified sealant
Control shaft assembly
MS721-40 or MS721-38
...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline (TJ) to prevent damage
to the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Crankshaft Damper Pulley Components
1. Crankshaft damper pulley
...
Copyright © www.kifomanual.com 2014-2025