Kia Forte: Control Cable Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Removal
| 1. |
Remove the floor console assembly.
(Refer to Body - " Floor Console")
|
| 2. |
Remove the select cable (B) by removing the snap pin (A).
|
| 3. |
Remove the shift cable (B) after removing the clip (A).
|
| 4. |
Remove the cable socket (A) from lever assembly after pulling
the cable socket clip in the direction of the arrow.
|
| 5. |
Remove the retainer (A) after loosen the nut (B).
|
| 6. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 7. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
| 8. |
Remove the shift & select cable.
|
| 9. |
Remove the shift cable at cabin room.
|
Control Cable Inspection
1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
...
Control Cable Installation
•
When installing, set room side Shift lever and T/M side
lever to N position.
...
See also:
Purge Control Solenoid Valve (PCSV) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the purge control solenoid valve connector (A) ...
Description
The SMART KEY system is a system that allows the user to access and operate
a vehicle in a very convenient way. To access the vehicle, no traditional key
or remote control unit is needed.
...
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...
Copyright © www.kifomanual.com 2014-2025