Kia Forte: Control Shaft Complete Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Removal
| 1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
| 3. |
Set shift lever to "N" position.
|
| 4. |
Separate the control cable from the control shaft after remove
the pin (A) and washer (B).
|
| 5. |
Remove the control shaft assembly after loosen the bolts.
|
Control Shaft Complete Description
Component location : Control shaft
assembly is mounted on the top of the manual transaxle
Function : Change the gear by shifting
a shift lever. ...
Control Shaft Complete Installation
1.
Install in the reverse order of removal.
•
...
See also:
Circuit Diagram
...
Rear Torsion Beam Axle Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...
Drive Belt Installation
1.
Install the drive belt.
(1)
Install the drive belt (C).
(2)
Adjust the tension by t ...
Copyright © www.kifomanual.com 2014-2025