Kia Forte: Cooling Fan Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Inspection
| Fan Motor |
| 1. |
Disconnect the fan motor connector from the resistor.
|
| 2. |
Connect the battery voltage to the "+" terminal and ground to
"-" terminal.
|
| 3. |
Check the cooling fan motor operates well.
|
Cooling Fan Disassembly
1.
Remove the cooling fan (A) from the cooling fan assembly.
2.
Disconnect the fan motor connector (A) from the resistor.
...
Radiator Components
1. Radiator
2. Radiator upper mounting bracket
3. Lower mounting insulator
4. Radiator upper hose
5. Filler neck assembly
6. Radiator lower hose
7. Clamp
...
See also:
Rear Hub - Carrier Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from ...
Intake Air Temperature Sensor (IATS) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS termi ...
TJ Joint Replacement
•
Special grease must be applied to the driveshaft joint.
Do not substitute with another ...
Copyright © www.kifomanual.com 2014-2025